Roofing discussions and local services.
paule25
Discussion activity
Topics and replies this member has contributed.
RE: When the stitching starts to show
I get the worry about splitting those old boards, but honestly, I’ve had more luck with a sharp scraper and some patience than with heat. Maybe it’s just my luck, but every time I try the heat gun, I end up with either s...
RE: Anyone else tried those mushroom-style roof vents on sheds?
Mixing vent types has been a headache for me too. When I moved in, our little backyard shed already had a ridge vent, but I figured more was better and slapped on two mushroom vents. Ended up with the same musty smell yo...
RE: Making sure the deck’s ready for underlayment - what’s your process?
Had a similar thing happen when I bought my place - roof looked fine from outside, but once I poked around the attic, found some soft spots near a vent pipe. Ended up replacing a couple sheets of decking. Now I always ch...
RE: Spotting wear and tear on used gear: my quick routine
I get where you’re coming from about the stainless, but honestly, I’ve had mixed luck with it. Maybe it’s just me, but I found the sharp edges a hassle and actually nicked a couple wires last fall. Plus, on my old clay ...
RE: Lowered my insurance bill after a roof inspection - anyone else surprised?
Totally get that. We replaced our old shingles with architectural ones last spring, hoping for a break on premiums. It worked for about six months, then rates jumped again - same “regional risk” excuse. Makes you wonder ...
RE: Weighing the pros and cons: full roof removal vs. just adding a new layer
Had to make this call last summer on our 60s ranch. That’s what sold me. Pulled up two layers of old shingles and found half the plywood was soft. Would’ve never caught it with another layer. Cost more up front, but at ...
RE: How long can you wait before that leaky roof becomes a real problem?
That sounds all too familiar. I waited a bit too long on a small leak in my attic, thinking it was just condensation or something minor. By the time I realized it was the roof, the water had already soaked into the insul...
RE: Avoiding Commercial Project Underbids
That “standard materials” bit drives me nuts too. When I was getting quotes for my kitchen reno, one contractor kept dodging specifics - just “standard cabinets, standard counters.” Turns out, his “standard” was particle...
RE: Ventilation in new builds - are we overlooking something important?
I’ve wondered about the green roof thing too. My neighbor put one in a couple years back - just a small section, but it’s held up way better than my “regular” vented roof. I’m not sure if it’s the extra weight holding ev...
RE: Best ways to protect home from extreme weather combo?
We had rain chains at our last place, and honestly, they were mostly decorative. During regular showers, they worked fine - looked nice, sounded relaxing - but once we got hit by a big storm, it was a different story. Wa...
RE: Roof checkups saved me big bucks - anyone else?
Had a similar thing happen last spring - noticed a weird dark spot in the attic insulation. Almost ignored it, but decided to poke around... turned out a vent seal had cracked. Quick patch-up saved me from mold nightmare...
RE: Roofing near the ocean - did you know salt air eats metal?
We bought our first home near the coast about five years ago and had a similar learning curve. The previous owners had installed aluminum flashing, which seemed fine at first glance. Honestly, I didn't even think twice a...
RE: LOOKING FOR GOOD PLACES TO BUY METAL ROOFING SHEETS
I went through something similar a couple years back when I bought my first place. Thought I'd save some cash ordering metal roofing sheets online - big mistake. The delivery was delayed twice, and when they finally arri...
RE: Finally tackled that metal edging thing on my roof
Wish I'd read this thread before my first attempt last summer. I went straight in with a metal hammer thinking "how hard can it be?"... famous last words. Ended up with dents everywhere and a seam that split wide open. T...
RE: Quick fix or redo: dealing with damaged aluminum flashing
Had a similar issue when I first moved into my place. The flashing around the chimney looked decent enough, just a couple minor dents - figured it wasn't worth fussing over. Fast forward to the next heavy rainstorm, and ...