When budgeting for a CertainTeed roof, ventilation definitely deserves attention, but don't overlook underlayment and ice/water shield either. I've se...

Haha, ain't that the truth... I've found if you keep your membrane clean and dry beforehand, even higher temps can work fine. Usually I aim for around...

Couldn't agree more on alignment checks—nothing worse than stepping back after a few shingles and realizing you've drifted off-center. One trick I've ...

Honestly, marine-grade is great but might be overkill unless you're literally right on the beach. I've had good luck with galvanized hardware combined...

I totally get where you're coming from. I've had my fair share of headaches dealing with overly complicated gadgets, and honestly, there's nothing wor...

Yeah, mesh guards can be tricky with smaller stuff like pine needles. Had the same issue myself a while back. One workaround I found helpful was switc...

I get your point, but sometimes jumping straight into a weekend overhaul isn't always the best route. I've found that occasionally living with a tempo...

Had a similar issue a couple years back—thought I was losing my mind chasing down phantom drips. Turned out the insulation was pushed up too close to ...

Good tip on drone altitude—definitely cuts down on neighbor anxiety. I'd also suggest snapping some quick photos of problem areas beforehand. Makes it...

I've had pretty similar luck with coated deck screws, especially if they're the ones specifically rated for outdoor use. One thing I've found helpful ...

I've used modular trays for green roofing in a pretty chilly climate (think Midwest winters, plenty of snow and ice), and honestly, they've held up su...

Good points all around. I'd also add that tile quality isn't just about brand names—it's about matching the tile type to your local climate. I've seen...