I’ve actually had the opposite experience during high winds—my composite tiles have been solid, but I did have one section near a ridge cap that start...
That’s a pretty familiar story—power tools can be a real gamble secondhand. I’ve had my share of “bargains” that turned out to be more trouble than th...
That’s been my experience too—those “impact-resistant” discounts sound good on paper, but when I ran the numbers after my last roof replacement (went ...
I hear you on the hose test—it’s definitely not foolproof, especially in places with crazy wind-driven rain. I’ve actually found a few leaks only afte...
UV exposure is definitely the main culprit in my area, too—hot summers, barely any cloud cover. I’ve actually tried a few different brands over the ye...
I get where you’re coming from on the ventilation. There’s a lot of marketing around it, but in my experience, it’s more about preventing major issues...
I mostly agree with your “seal, insulate, ventilate” sequence, but I’d push back a bit on the idea that airflow is something to always minimize after ...
I used to roll my eyes at that level of detail, but after a minor flashing issue turned into a $2k repair, I’m on board. Midwest freeze-thaw cycles ar...
That’s been my experience too—those “impact-resistant” shingles sound great in theory, but the math on the payback is pretty underwhelming. My insuran...
That’s spot on about ventilation being just as important as the underlayment. I went with Deck-Armor on a reroof about five years ago, and while it’s ...
That’s spot on. I’ve seen a neighbor deal with exactly that—looked great at first, but a couple years in, they had condensation pooling under the pane...
Totally agree on the hidden moisture issue—had a similar experience myself. Our installer actually recommended a moisture scan and structural check sp...
Exactly, attic ventilation is often overlooked. I've seen cases where homeowners upgraded insulation thinking it would help, but without proper airflo...
It’s definitely a balance between temperature and feel. Generally speaking, you'll want your heat gun around 950°F to 1050°F (500°C to 565°C) for TPO ...
I've been noticing the same trend and suspect it's a combination of both factors. Shingle manufacturers have definitely adjusted their asphalt blends ...