Finally tackled that metal edging thing on my roof

"Stainless might feel like overkill, but it's a safer bet long-term."

Fair point, but honestly, stainless isn't always the magic bullet either. I've seen stainless screws seize up or gall pretty badly, especially if you're not careful installing them. Had a job last year where we ended up snapping heads off stainless screws left and right - total nightmare. Galvanized can definitely rust quicker near the coast, no argument there, but if you're inland or even moderately humid, quality coated screws (like ceramic-coated deck screws) can be a solid middle ground. They're cheaper than stainless, resist corrosion better than standard galvanized, and I've had good luck with them holding up over time. Just throwing another option out there...

Yeah, stainless can be tricky - I learned that the hard way too. Ended up stripping a bunch of screws on my first DIY project... nightmare. Ceramic-coated screws have held up surprisingly well for me since then, so definitely worth considering. Good luck with the roof!

"Ended up stripping a bunch of screws on my first DIY project... nightmare."

Haha, been there myself - stainless screws can be a real pain if you're not careful. One trick I've found helpful is pre-drilling pilot holes slightly smaller than the screw diameter. Makes life way easier and saves you from the dreaded stripped screw scenario. Ceramic-coated screws are solid too, especially if you're dealing with moisture or coastal conditions. Either way, sounds like you're on the right track now... roofs are tricky enough without hardware drama slowing you down.

Been down that road myself... stripped screws are like a DIY rite of passage, haha. Pilot holes definitely help, but I've also had luck using an impact driver - makes a huge difference. Keep at it, gets easier each time.

Yeah, stripped screws are the worst... I've definitely been there. Impact drivers are a lifesaver, but sometimes even those stubborn screws need a bit of WD-40 or some patience. Glad you got through it - roof edging can be tricky at first.