Yeah, I’ve tried patching with tape too—never holds up once the weather gets serious. I’ll admit, I’ve reused old flashing in a pinch, but it’s usually more hassle than it’s worth. If the bend’s bad, water will sneak right in. Ice-and-water shield is a lifesaver under shingles, but I wish there was a greener option that actually worked. Never heard of using inner tubes either... sounds like a last resort, but hey, whatever keeps the rain out for a night.
Yeah, I hear you on the tape—tried that during a freak storm last fall and it peeled right off after two days of rain. I’ve also reused old flashing, thinking I’d save a few bucks, but it never sits quite right and I end up chasing leaks anyway. Ice-and-water shield has been my backup too, though I’m with you on wishing there was something less plastic-heavy. The inner tube trick is new to me... desperate times, right? Sometimes you just gotta get creative to keep the water out, even if it’s not pretty.
Sometimes you just gotta get creative to keep the water out, even if it’s not pretty.
I get the urge to improvise, but honestly, those “creative” fixes usually end up costing more in the long run. Reused flashing almost never seals right—seen way too many attic stains from that. If the aluminum’s warped or corroded, I’d rather just bite the bullet and replace it. Temporary patches might hold for a storm or two, but water always finds a way.
Totally get wanting to patch things up in a pinch, but I’ve seen too many “quick fixes” just redirect leaks somewhere worse. If the flashing’s bent or pitted, I just swap it out. Saves a lot of headaches down the line—especially after heavy storms.
If the flashing’s bent or pitted, I just swap it out. Saves a lot of headaches down the line—especially after heavy storms.
Yeah, I learned that one the hard way... Thought I could just slap some sealant on a dented piece and call it good. Next rain, water found a whole new path—right into my closet. Swapping it out is definitely less painful than chasing leaks all over the place.
