That drumline sound—yeah, I’ve heard that from a few folks after switching to composite. Did you notice if they put in any extra insulation or sound barrier? Sometimes just a thin layer gets skipped and it makes all the difference during storms. I’ve crawled through more attics than I can count and found gaps behind chimneys or around vents... even on jobs where the crew swore everything was tight. Ever seen wind push rain sideways and sneak right through a missed seam? It’s wild how one little spot can cause so much fuss.
Ever seen wind push rain sideways and sneak right through a missed seam? It’s wild how one little spot can cause so much fuss.
That’s the truth—one tiny gap and suddenly you’re chasing leaks for weeks. I’ve seen it happen even with brand new installs. Did your crew use any kind of self-sealing membrane around the vents or just standard flashing? Sometimes that makes all the difference, especially in places with wild weather swings.
Yeah, I’ve definitely chased my share of leaks from little gaps like that—sometimes it’s the tiniest spot you’d never expect. I’m with you on the self-sealing membrane; after one bad winter a few years back, I started insisting on it around every vent and skylight. The standard flashing just didn’t cut it when we had those sideways rains and freeze-thaw cycles.
With composite tiles, I actually noticed the installers spent more time sealing up the penetrations compared to when I had asphalt shingles. Maybe it’s overkill, but after dealing with water sneaking in before, I’d rather be safe. Did you notice any difference in how your crew handled the seams with composites vs. traditional materials? I’m curious if that’s just my installer or if it’s standard practice now.
Funny thing is, even with all the new tech and materials, sometimes it still comes down to the guy holding the caulk gun...
- Noticed the same thing with my install—crew spent way more time fussing over the seams and flashing than I expected.
- With my old asphalt roof, it felt like they just slapped stuff down and moved on. Composites seemed to get more attention, especially around the vents and skylights.
- Not sure if that’s just because I was hovering more this time or if it’s standard now.
- Still a little skeptical about how much of it is “new material” vs. just better labor, honestly.
- Either way, I’d rather have them go overboard than cut corners...but yeah, still feels like a lot depends on who’s actually doing the work.
- Noticed the same thing when I helped out on a composite job last month. Crew spent forever on the flashing and ridge caps—way more than with asphalt.
-
“Composites seemed to get more attention, especially around the vents and skylights.”
- Think it’s partly the material—composite tiles are stiffer, so you can’t just bend them into place like shingles.
- Also, some of the older guys I work with say it’s just better practice now, since leaks usually start at those spots.
- Honestly, I’d rather see them take their time. Rushing flashing is how you end up with callbacks...